AT Commands Dart Dart 300 Equivalent, Aip/n

DART 300 Migration Guide		Comparative AT Command Reference
Table 4-4: AT [*] Commands (continued)

Command	DART 200	DART 300 Equivalent

*S	SLIP Mode Initiate	SLIP Mode Initiate
	Initiates a SLIP session on the serial port. It is	SLIP sessions are started or re-entered with the
	also used to return to SLIP mode following an	ATO (On-line) command.
	escape.
*T	Telnet Keep-Alive	Telnet Keep-Alive
	Allows the modem to time out, or keep-alive a	Not supported.
	telnet session with no current activity. Similar
	to the function of *K.
*U	Unblock Modem PIN Access	Unblock Modem PIN Access
	Used to unblock the modem if the PIN is	Not supported.
	forgotten or is entered incorrectly 3 times.

The Carat (^) command set is only available on the DART 200. The DART 300 uses alternative commands or registers where equivalents exist.

Table 4-5: AT [^] Commands

Command	DART 200	DART 300 Equivalent

^A	Address Set	Active NEI Write
	Loads an IP Address into one of the 10 slots in	The DART 300 uses an index register
	the DART 200’s NEI list.	(+WS197) to access a table of four NEIs.
		^A<ip>/<n>
		= +WS197=<n>+WPNEI=<ip>
		Erasing an NEI is accomplished by writing an
		IP address of 0.0.0.0
^C	Clear Blocked Status	Clear Blocked Status
	Clears the blocked status of the PIN.	Not supported.
^F	Force PIN Usage	Force PIN Usage
	Specifies whether or not modem users require	Not supported.
	PINs.
^G	GMID – Multicast Group ID	Consult the DART 300 User Guide for details
	Attaches a GMID to the user-defined multicast	on multicast operation.
	NEI.
^H	Set SPI	Set SPI
	Loads an SPI into one of the 10 slots in the	Not supported.
	DART’s SPI table
^I	Set SPNI	Service Provider Network ID Table Write
	Loads a SPNI into one of the 10 slots in the	The DART 300 does not index the SPNI list.
	DART’s SPNI table	The entire list is replaced with each write.
		^H<spni>/<n>
		= +WPSPNI=[spni[,spni2[,…]]]>

2110291 Rev 1.0

Page 27