2
8
BLW-54MF
3.ConnectLAN Cables.
Use standard LAN cables (RJ-45) to connect PCs to the switching hub
ports on BLW-54MF.Both 10 Base-T and 100 Base-T connections can
beused simultaneously.
4.ConnectWAN Cable.
Connectthe DSL or Cable modem to the WAN port on BLW-54MF.
5.PowerOn.
Power the DSLor Cable modem on. At last, connect the adapter with
BLW-54MFand plug t he other side of the power cord into the power
socket. Power BLW-54MF Wireless Router on. While detecting, the
PowerLED will be on and then the BLW-54MF will be ready in a short
time.
2. Client's Computer Setup
The computers on your LAN need to be set up to cooperate with BLW-
54MFWireless Router.
Pleasemake sure that your operating system already enabled your interface
card on the host and connected to one of the LAN ports on BLW-54MF
through CAT-5cable. Be sure that LEDs on BLW-54MFare al ready
on and the LED corresponds with the port which you connected. If you
switchon BLW-54MF for the first time, owing to the default status, it will
automatically enable the embedded DHCPserver and start to distribute
IPto your host. In addition, the default IP address of BLW-54MF is
ņ192.168.1.1.ŇIf your operating system isWindows 98/2000/XP, you
may be able to use command ofņipconfigŇto inquire whether you have
thecorrect IP address or not. If you are using Linux/Unix-Like system, you
can useņifconfigŇto check your NIC (Network Interface Card) address.
Theinstructions are as follows:
œWindows98
1.ClickņStartƖProgramsƖMS-DOSŇorņStartƖRunĀŇandtype
inņcommand.exeŇandthen press enter.