Instructions for the User
9.5What to do if...
The | oven | display is • | Check the mains power supply. | ||
completely off |
|
| • | Check whether an omnipolar switch upstream | |
|
|
|
|
| of the oven supply line is in the “ON” position. |
The oven does not heat up | • | Check whether it has been set in “showroom” | |||
|
|
|
|
| mode, for further details see “6.14 Secondary |
|
|
|
|
| menu”. |
The | controls | do | not • | Check whether it has been set in “child lock” | |
respond. |
|
|
| mode, for further details see “6.14 Secondary | |
|
|
|
|
| menu”. |
The | cooking | times | are • | Check whether it has been set in “PO” mode, | |
longer than those indicated |
| for further details see “6.14 Secondary menu”. | |||
in the table. |
|
|
|
| |
After | the | automatic • | Verify whether the door locking device has | ||
“pyrolysis” cleaning | cycle |
| switched off. If it has not, the oven has a | ||
(only on some models) it is |
| protection device that does not allow functions | |||
not possible to select a |
| to be selected while the door locking device is | |||
function. |
|
|
| active. This is because the temperature inside | |
|
|
|
|
| the oven is still too high to permit any type of |
|
|
|
|
| cooking. |
The display shows ERR 4 | • | The door locking device has not properly | |||
(on pyrolytic models only) |
| attached to the door. This might be because the | |||
|
|
|
|
| door was accidentally opened during its |
|
|
|
|
| activation. Switch off the oven and switch it on |
|
|
|
|
| again waiting a few minutes before selecting a |
|
|
|
|
| new cleaning cycle. |
If the door is opened during | • | This is not a fault. It is a normal operation of the | |||
a |
| appliance, useful when cooking foods in order | |||
fan stops. |
|
|
| to avoid excessive heat escaping. When the | |
|
|
|
|
| door is closed, the oven will return to normal |
|
|
|
|
| operation. |
If the problem has not been resolved or in the case of other types of fault, contact your local technical support centre.
61
