1. Start the Windows application that you want to receive the
data (e.g., Word Pad). Make sure a document is open.
2. Place the cursor where you want data from the next scan to
go.
1. Press the trigger button and scan the code.
When data is read and sent to the CK30, the scanner will beep
once, the LED will flash green, and the beam will turn off.
If no data is read in a few seconds, the scanner beam will turn
off, and you must try again.
After you scan a bar code, the CHS will not allow you to
scan another bar code for 10 seconds or until the host
device confirms receipt of the scanned data.
2. After a successful scan, data should appear in your document.
For example, after you scan a bar code into a spreadsheet,
data should appear in the first cell. The default “CR” (carriage
return) suffix will advance the cursor to the next cell, ready
for the next scan.
Wait for the “Good Scan” indication before you scan another
bar code. If you try to scan too fast, the device can lock up until
you stop scanning.
SocketScan Auto-Reconnect
36