STEP 7: SCAN DATA INTO YOUR APPLICATION 1. Press the trigger button and scan the bar code.
When data is read and transmitted to the host, the scanner
will beep once, the LED will flash green, and the beam will
turn off.
If the Scanner fails to read data within a few seconds, the
scanner beam will turn off, and you must try again.
2. After a successful scan, data should appear in your document.
For example, after you scan a bar code into a Memo, data
should appear in the first line. The default “CR” (carriage
return) suffix will advance the cursor to the next line, ready
for the next scan.
Wait for the “Good Scan” indication before you scan another
bar code. If you try to scan too fast, the device can lock up
until you stop scanning.
Turning off the CHS
To turn off the CHS, press and hold the power button for at least
3 seconds, until the blue LED turns off.
CHAPTER 6: SETUP FOR PALM OS 71