STEP 7: SCAN DATA INTO YOUR APPLICATION 1. Press the trigger button and scan the bar code.
When data is read and transmitted to the smartphone, the
scanner will beep once, the LED will flash green, and the
beam will turn off.
If the Scanner fails to read data within a few seconds, the
scanner beam will turn off, and you must try again.
After you scan a bar code, the CHS will not allow you to
scan another bar code for 10 seconds or until the
smartphone confirms receipt of the scanned data.
2. After a successful scan, data should appear in your document.
The default “CR” (carriage return) suffix will advance the
cursor to the next line, ready for the next scan.
Wait for the “Good Scan” indication before you scan
another bar code. If you try to scan too fast, the device
can lock up until you stop scanning.
To disconnect, in the SocketScan menu, click Disconnect CHS.
Turning off the CHS
To turn off the CHS, press and hold the power button for at least
3 seconds, until the blue LED turns off.
80