18
Corrections
Error
A food has been added to the
accumulator under the wrong code
number.
A food has been added to the
accumulator under the wrong code
number, but the error was noticed
immediately.
Correction
Enter the wrong code, press "INP",
enter the value, press "+/–". The
wrong value is deleted from the
accumulator when "M+" is pressed.
Leave the foodstuff on the weighing
surface, eliminate the value by
pressing "TARA", then remove the
food from the weighing surface and
subtract the negative value from the
accumulator total by pressing "M+".
Individual digits can be deleted by
pressing "MR" during manual input.
CHANGING THE CARBOHYDRATE CONVERSION FACTOR (BE)
The BE values saved in the diet computer are adapted to the formula:
1 BE = 10 g carbohydrate (factor 0.1).
If you wish to convert the BE values to the bread unit equivalent used
in the past (1 bread unit equivalent (BE) = 12 g carbohydrate), press the
"INP" key first and then the "BE" key. After entering factor 0.083 and
confirming with the carbohydrate key, press the "INP" key once more.
Your diet computer automatically reverts to the normal weighing mode.
CHANGING THE SET FOODS
If you wish to change the foods programmed into the diet computer,
first of all switch the scales to weighing mode and then enter the
code number of the food to be changed.
Press the "INP" key and then the key for the nutritional value
concerned. Key in the value per 100 g of weight, or liquid density.
Use the decimal point key on the numerical keypad instead of
the comma.