SonicWALL 3500 Configuring the Secondary Bridge Interface, If You Are Following, Scenario, page

Configuring the Secondary Bridge Interface

Complete the following steps to configure the SonicWALL appliance:

1.Navigate to the Network > Interfaces page from the navigation panel.

2.Click the Configure icon in the right column of the X0 (LAN) interface.

3.In the IP Assignment drop-down, select Layer 2 Bridged Mode.

4.In the Bridged to drop-down, select the X1 interface.

5.Configure management options (HTTP, HTTPS, Ping, SNMP, SSH, User logins, or HTTP redirects).

Note: Do not enable Never route traffic on the bridge-pair unless your network topology requires that all packets entering the L2 Bridge remain on the L2 Bridge segments.

You may optionally enable the Block all non-IPv4 traffic setting to prevent the L2 bridge from passing non-IPv4 traffic.

If You Are Following	Proceed to Section:
Scenario...
C - L2 Bridge Mode	Additional Deployment Configuration
	- page 37

Page 36 Configuring L2 Bridge Mode