SonicWALL 3500 Safety and Regulatory Information, Rack Mounting the SonicWALL, Cable Connections

Safety and Regulatory Information

Regulatory Model/Type	Product Name
1RK13-051	NSA 5000
1RK13-051	NSA 4500
1RK13-052	NSA 3500

Rack Mounting the SonicWALL

The above SonicWALL appliances are designed to be mounted in a standard 19-inch rack mount cabinet. The following conditions are required for proper installation:

•Use the mounting hardware recommended by the rack manu- facturer and ensure that the rack is adequate for the applica- tion.

•Four mounting screws, compatible with the rack design, must be used and hand tightened to ensure secure installation. Choose a mounting location where all four mounting holes line up with those of the mounting bars of the 19-inch rack mount cabinet.

•Mount in a location away from direct sunlight and sources of heat. A maximum ambient temperature of 104º F (40º C) is recommended.

•Route cables away from power lines, fluorescent lighting fix- tures, and sources of noise such as radios, transmitters and broadband amplifiers.

•The included power cord is intended for use in North America only. For European Union (EU) customers, a power cord is not included.

•Ensure that no water or excessive moisture can enter the unit.

•Allow unrestricted airflow around the unit and through the vents on the side of the unit. A minimum of 1 inch (25.44mm) clearance is recommended.

•Mount the SonicWALL appliances evenly in the rack in order to prevent a hazardous condition caused by uneven mechan- ical loading.

•Consideration must be given to the connection of the equip- ment to the supply circuit. The effect of overloading the circuits has minimal impact on overcurrent protection and supply wir- ing. Appropriate consideration of equipment nameplate rat- ings must be used when addressing this concern.

•Reliable grounding of rack-mounted equipment must be main- tained. Particular attention must be given to power supply connections other than direct connections to the branch cir- cuits such as power strips.

Lithium Battery Warning

The Lithium Battery used in the SonicWALL Internet security appliance may not be replaced by the user. The SonicWALL must be returned to a SonicWALL authorized service center for replacement with the same or equivalent type recommended by the manufacturer. If, for any reason, the battery or SonicWALL Internet security appliance must be disposed of, do so following the battery manufacturer's instructions.

Cable Connections

All Ethernet and RS232 (Console) cables are designed for intra-building connection to other equipment. Do not connect these ports directly to communication wiring or other wiring that exits the building where the SonicWALL is located.

Page 66 Safety and Regulatory Information