Connecting the LAN Port
1.Connect one end of the provided Ethernet cable to the computer you are using to manage the SonicWALL NSA Series.
2.Connect the other end of the cable to the X0 port on your SonicWALL NSA Series.
The Link LED above the X0 (LAN) port will light up in green or amber depending on the link throughput speed, indicating an active connection:
-Amber indicates 1 Gbps
-Green indicates 100 Mbps
-Unlit while the right (activity) LED is illuminated indicates 10 Mbps
Applying Power
1.Plug the power cord into an appropriate power outlet.
2.Turn on the power switch on the rear of the appliance next to the power cords.
I o
To power source 
The Power LEDs 
on the front panel light up blue when you
plug in the SonicWALL NSA . The Alarm 
LED may light up
and the Test | LED will light up and may blink while the |
appliance performs a series of diagnostic tests.
When the Power LEDs are lit and the Test LED is no longer lit, the SonicWALL NSA is ready for configuration. This typically occurs within a few minutes of applying power to the appliance.
Note: If the Test or Alarm LEDs remain lit after the SonicWALL NSA appliance has been booted, restart the appliance by cycling power.
