Charging and installing the battery pack
Battery life
Battery pack | ||||
|
|
|
| |
Continuous recording time1) | 110 (100) | 250 (225) | 400 (360) | |
(min.) | ||||
|
|
| ||
|
|
|
| |
Typical recordng time2) | 65 (60) | 150 (135) | 225 (200) | |
(min.) | ||||
|
|
| ||
|
|
|
|
The available time for a fully charged battery is indicated outside parentheses. The available time for normal charged battery is indicated in parentheses. Battery life will be shorter if you use the camcorder in a cold environment.
1)Approximate continuous recording time indoors.
2)Approximate minutes when recording while you repeat recording start/stop, zooming and turning the power on/off. The actual battery life may be shorter.
Note on remaining battery time indication during recording
Remaining battery time is displayed in the viewfinder. However, the indication may not be displayed properly, depending on the conditions and circumstances of use.
To remove the battery pack
Slide the battery pack in the direction of the arrow.
Notes on charging the battery pack
•The CHARGE lamp will remain lit for a while even if the battery pack is removed and the power cord is unplugged after charging the battery pack. This is normal.
•If the CHARGE lamp does not light, disconnect the power cord. After about one minute, reconnect the power cord again.
•You cannot operate the camcorder using the AC power adaptor while charging the battery pack.
•When a fully charged battery pack is installed, the CHARGE lamp will light once, then go out.
Getting started
7
