Recording from a VCR or TV
Replacing recording on a tape (insert editing)
You can insert a new scene from a VCR onto your originally recorded tape by specifying starting and ending points.
Connections are the same as in “Recording from a VCR or TV” on the previous page.
(1) While pressing the small green button on the POWER switch, set it to VTR.
(2) On the VCR, locate the start point to be inserted and set it to playback pause mode.
(3) On the camcorder, locate the point where the insert should end by pressing
0or ), then press Pto set it to playback pause mode.
(4) Press COUNTER RESET to set the counter to zero.
(5) On the camcorder, locate the point where the insert should begin by pressing 0, then press rREC and Pto set it to recording pause mode.
(6) Press ZERO MEM on the Remote Commander. The ZERO MEM indicator flashes and the end point of the insert is stored in memory.
(7) Press Pon the camcorder and the VCR simultaneously to start insert editing. The insert editing stops automatically near the counter’s zero point.
To change the end point
Press ZERO MEM on the Remote Commander so that the ZERO MEM indicator disappears and begin from step 3.
Note on the inserted picture
The picture may be distorted at the end of the inserted portion when it is played back.
70
