Adjusting the volume of the subwoofer(s)

1 Press (SOURCE) to select a source (tuner, CD, or MD).

2 Press (SOUND) repeatedly until “SUB” appears.

3 Press either side of (SEEK/AMS) to adjust the volume level.

4 Press (MENU) twice.

After three seconds, the display returns to the normal playback mode.

Tip

When you lower the volume all the way down, “ATT” appears and the cut-off frequency of the subwoofer is disabled.

Adjusting the frequency of the subwoofer(s)

To match the characteristics of the connected subwoofer(s), you can cut out the unwanted high and middle frequency signals entering the subwoofer(s). By setting the cut-off frequency (see the diagram below), the subwoofer(s) will output only low frequency signals so you can get a clearer sound image.

Level

Cut-off frequency

 

Frequency (Hz)

1 Press (MENU).

2 Press either side of (DISC/PRST) repeatedly until “SUB LPF” appears, then press (ENTER).

3 Select the desired frequency and level.

1Press either side of (SEEK/AMS) to select the desired frequency.

Each time you press (SEEK/AMS), the frequency changes as follows:

62 Hz y 78 Hz y 99 Hz y 125 Hz y 157 Hz y off

2Press either side of (DISC/PRST) to adjust the desired volume level.

The volume is adjustable by 1 dB steps from –12 dB to +12 dB.

4 Press (MENU) twice.

After the frequency setting is complete, the display returns to the normal playback mode.

Tip

When you lower the volume all the way down, “ATT” appears and the cut-off frequency is disabled.

Listening to each programme source in its registered DSO

—Source Sound Memory (SSM)

Each time you return to the same source, you can hear the same DSO menu and equalizer curve registered for that source, even after changing the programme source or turning the unit off and then on again.

25

01US05RAD-U.p65

25

1/20/00, 10:14 PM