Press (MENU).
Changing the sound and display settings

The following items can be set:

SET

•Clock (page 10)

•Beep - to turn on or off the beeps.

•RM (Rotary Commander) - to change the operative direction of the controls of the rotary commander.

—Select “norm” to use the rotary commander as the factory-set position.

—Select “rev” when you mount the rotary commander on the right side of the steering column.

•Multi language (language selection) - to change the display language to English, French, or Spanish.

•D.Info (Dual Information) - to display the clock and the play mode at the same time (on) or to display the information alternately (off).

DIS

•SA (Spectrum Analyzer) - to change the display pattern of the equalizer display.

•Dimmer - to change the brightness of the display.

—Select “Auto” to dim the display only when you turn the lights on.

—Select “on” to dim the display.

—Select “off” to deactivate Dimmer.

•Contrast - to adjust the contrast if the indications in the display are not recognisable because of the unit’s installed position.

•M.Dspl (Motion display) - to turn the motion display to 1, 2 , or off.

•A.Scrl (Auto Scroll) (page 13)

1

2 Press either side of (DISC/PRST) repeatedly until the desired item appears.

Each time you press (–) side of (DISC/PRST), the item changes as follows:

Example:

Clock t Beep t RM t Multi language t D.Info t SA t Dimmer t Contrast t M.Dspl t A.Scrl t Local t Mono t IF t EQ Tune t Front HPF t Rear HPF t SUB LPF

tName edit t NameDel t BTM

Note

The displayed item will differ depending on the source.

Tip

You can easily switch among categories (“SET”, “DIS”, “P/M”, “SND” and “EDT”) by pressing and holding either side of (DISC/PRST) for two seconds.

3 Press either side of (SEEK/AMS) to select

the desired setting (Example: “on” or “off”).

4 Press (ENTER).

After the mode setting is complete, the display returns to normal playback mode.

SND

•EQ Tune (Equalizer tuning) - to adjust the frequency and volume level of the equalizer curve.

•Front HPF (High pass filter for the front pre- output) - to select the cut-off frequency of the front pre-output.

•Rear HPF (High pass filter for the rear pre- output) - to select the cut-off frequency of the rear pre-output.

•SUB LPF (Low pass filter for the subwoofer output) - to select the cut-off frequency of the subwoofer output.

29

01US06OTH-U.p65

29

1/20/00, 10:14 PM