The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures.
General
Problem | Cause/Solution |
|
|
No sound. | •Cancel the ATT function. |
| •Set the front or rear fader control to the center position for |
| |
| •Rotate the dial clockwise to adjust the volume. |
The contents of the memory have been erased.
•The power cord or battery has been disconnected.
•The reset button has been pressed. t Store again into the memory.
Indications do not appear in the Remove the front panel and clean the connectors. See
display. | “Cleaning the connectors” (page 33) for details. |
No beep sound. | The beep sound is canceled (page 29). |
|
|
The card remote commander | •Remove any obstacles blocking the signal path from card |
does not function. | remote commander to the unit. |
| •Point the card remote commander at the receptor on the unit. |
|
|
36
36 | 1/20/00, 10:14 PM |