The subtitle language cannot be changed.

•Multilingual subtitles are not recorded on the DVD being played.

•The DVD prohibits changing the subtitles.

The subtitle cannot be turned off.

• The DVD prohibits turning off subtitles.

The angles cannot be changed.

•Multi-angles are not recorded on the DVD being played.

•The DVD prohibits changing the angles.

Tuner

Severe hum or noise/stations cannot be received. (“TUNED” or “STEREO” flashes in the display)

•Set the proper band and frequency (page 28).

•Connect the antenna properly (page 10).

•Find a place and an orientation that provide good reception, then set up the antenna again. If you cannot obtain good reception, we recommend you connect a commercially available external antenna.

•The supplied FM lead antenna receives signals along its entire length, so make sure you extend it fully.

•Locate the antennas as far away from the speaker cords as possible.

•Consult your nearest Sony dealer if the supplied AM antenna has come off the plastic stand.

•Try turning off surrounding electrical equipment.

A stereo FM program cannot be received in stereo.

•Press FM MODE repeatedly until “MONO” disappears.

Tape deckThe tape does not record or play, or there is a decrease in sound level.

•The heads are dirty. Clean them (page 50).

•The record/playback heads are magnetized. Demagnetize them (page 50).

The tape does not erase completely.

•The record/playback heads are magnetized. Demagnetize them (page 50).

There is excessive wow or flutter, or the sound drops out.

•The capstans or pinch rollers are dirty. Clean them (page 50).

Noise increases or the high frequencies are erased.

•The record/playback heads are magnetized. Demagnetize them (page 50).

The tape does not record.

•No cassette is loaded. Load a cassette.

•The tab has been removed from the cassette. Cover the broken tab with adhesive tape (page 50).

•The tape has wound to the end.

•Set “Dolby Digital” or “DTS” under “AV” to “PCM.”

“TAPE ERR” appears in the display.

•Press ?/1 to turn off the system and remove any tapes from the cassette holder. Then disconnect the power cord and reconnect it. Then press ?/1 to turn on the system.

If “TAPE ERR” still appears, consult your nearest Sony dealer.

Optional components

There is no sound.

 

• Refer to General item “There is no sound.”

 

(page 44) and check the condition of the system.

 

• Connect the component properly (page 41) while

 

checking:

 

Troubleshooting

– if the cords are connected properly.

 

– if the cord plugs are firmly inserted all the way.

 

• Turn on the connected component.

 

• Refer to the operating instructions supplied with

 

the connected component and start playing.

 

 

 

 

continued

47GB