same time.
The system is reset to the factory settings except for DVD settings. You should set the settings you made, such as the preset stations, clock, and timer.
To return the DVD setup to the default settings*, perform reset as follows:
The operation can only be set using the TV screen.
Press x, PLAY MODE and DVD NX at the
6
Press DVD NX to switch the function to DVD and make sure that “NO DISC” is displayed.
Press ?/1 to turn on the system.
Reconnect the power cord.
Disconnect the power cord.
1 Remove the disc if it is loaded.
2
3
4
5
If the system still does not operate properly after performing the above measures, reset the system as follows:
Use buttons on the unit for the operation.
1Press DISPLAY in stop mode.
2Press < or , repeatedly to select “Reset,” then press ENTER.
3Press < or , repeatedly to select “YES,” then press ENTER.
It takes a few seconds to complete. Do not press ?/1 when resetting the system.
* Except for Rating (Parental Control) settings
Messages
One of the following messages may appear or flash in the display during operation.
DVD/VIDEO CD/CD/MP3/JPEGCAN’T PLAY
•A disc that cannot be played was inserted.
•A disc with an unsupported Region code was inserted.
NO DISC
There is no disc in the unit.
NOT IN USE
You pressed an invalid button.
TapeNO TAB
You cannot record the tape because the tab has been removed from the cassette.
NO TAPE
There is no tape in the tape deck.
TAPE ERR
A malfunction of the tape deck has occurred.
48GB