TV channels cannot be changed.

,The channel is disabled (page 75).

,A timer recording started, which changed the channels.

The picture from equipment connected to the recorder’s input jack does not appear on the screen.

,If the equipment is connected to the LINE 1-TV jack, select “LINE 1” in the front panel display by pressing INPUT SELECT.

If the equipment is connected to the LINE 2 IN jacks, select “LINE 2” in the front panel display by pressing INPUT SELECT.

If the equipment is connected to the LINE 4 IN jacks, select “LINE 4” in the front panel display by pressing INPUT SELECT.

If the equipment is connected to the LINE 3/ DECODER jack, select “LINE 3” in the front panel display by pressing INPUT SELECT.

If the equipment is connected to the DV IN jack, (this is usually for a digital video camera connection), select “DV” in the front panel display by pressing INPUT SELECT.

The playback picture or TV programme from the equipment connected through the recorder is distorted.

,If the playback picture output from a DVD player, VCR, or tuner goes through your recorder before reaching your TV, the copy-protection signal applied to some programmes could affect picture quality. Disconnect the playback equipment in question and connect it directly to your TV.

The picture does not fill the screen.

,Set [TV Aspect] in [Settings] Setup in accordance with the aspect ratio of your TV (page 77).

The picture does not fill the screen, even though the aspect ratio is correctly set in [TV Aspect] in [Settings] Setup.

,The aspect ratio of the disc is fixed on your DVD.

The picture is black and white.

,If you are using a SCART cord, be sure to use one that is fully wired (21 pins).

SoundThere is no sound.

,The connecting cord is damaged.

,The input source setting on the supplied speaker system or the connection to the speaker system is incorrect.

,The recorder is in reverse play, fast forward, slow motion, or pause mode.

,If the audio signal does not come through the DIGITAL OUT (OPTICAL or COAXIAL) jacks, check the [Audio] Setup settings (page 79).

,Press MUTING if “MUTING ON” is displayed in the centre unit display.

,Check the speaker settings (page 14).

Sound is noisy.

,When playing a CD with DTS sound tracks, noise will come from the LINE 2 OUT (AUDIO L/R) jacks, LINE 1-TV jack, or LINE 3/ DECODER jack (page 55).

The sound volume is low.

,The sound volume is low on some DVDs. For the supplied speaker output, set “AUDIO DRC” in AMP menu to “DRC MAX” or “DRC STD” (page 87).

For other sound output, set [Audio DRC] in [Audio] setup to [On] (page 80).

An alternate audio track cannot be recorded or played.

,If an audio channel other than “Main+Sub” is selected, you cannot record both main and sub sounds. Check the selected audio channel before you start recording.

,To enjoy bilingual programmes through the supplied speaker system, select the audio channel in the “DUAL MONO” setting of the AMP menu (page 89).

Severe hum or noise is heard.

,Check that the speakers and components are connected securely.

,Check that the connecting cords are not too close to a transformer or motor, and at least three metres away from your TV set or any fluorescent lighting.

,Move your TV away from the system.

,The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol.

102