Sony DAR-RD100 Recording From Connected Equipment, Creating chapters in a title, Overwriting a recorded title, Notes, 6 Press z REC, Insert a DVD+RW, To stop recording

Insert a DVD+RW.

Set the AMP/DVD switch to DVD.

number, etc., shown in the front panel display (page 111).

Creating chapters in a title

The recorder automatically divides a recording (a title) into chapters by inserting chapter marks at 5, 10, or 15-minute intervals during recording. Select the interval, [5Min], [10Min], or [15Min] for [Auto Chapter] in [Rec Setting] Setup (page 82).

zHint

You can create chapters manually when playing a DVD+RW, DVD-RW (VR mode), or DVD+R (page 68).

Overwriting a recorded title

+RW

You can use the Title List to make a new recording over a title previously recorded on the disc. For details about the Title List, see page 33.

1

2

3 Press PROG +/– or INPUT SELECT to select a programme position or input source.

4 Press TITLE LIST to turn on the Title List.5 Press </M/m/, to select the title you want to overwrite.6 Press z REC.

Recording starts.

To stop recording

Press x. Note that it may take a few seconds for recording to stop.

zHint

If you erase a title from a DVD+RW, it appears as [Erased title] in the Title List. However, this will not increase the remaining time on the disc. You can select [Erased title] from the Title List and make a new recording on top of it (page 65).

Notes

•A protected title cannot be overwritten (page 66).

•If the selected title is shorter than the new recording, or less than ten seconds, the recorder automatically overwrites the next title in the Title List. If you do not want a title to be overwritten, protect the title (page 66).

Recording From Connected Equipment

+RW -RWVR-RWVideo+R -R

You can record from a connected VCR or similar device. To connect a VCR or similar device, see “Connecting a VCR or similar device” (page 24). Use the DV IN jack on the front panel if the equipment has a DV output jack (i.LINK jack).

Recording

1	2	3
4	5	6
7	8	9	INPUT
	0		SELECT

x

zREC REC MODE

1 Insert a recordable disc.

2 Press INPUT SELECT to select an input source according to the connection you made.

The front panel display changes as follows:

TV programme
position	LINE1	LINE2

DV LINE4 LINE3

3 Press REC MODE repeatedly to select the recording mode.

The recording mode changes as follows:

HQ SP EP SLP

4 Insert the source tape into the connected equipment and set to playback pause.

,continued 49