Getting Started
10 Press 
.
11 Connect the calibration mic to the A.CAL MIC jack on the front panel.
Set up the calibration mic at the ear level using a tripod, etc. (not supplied). The front of each speaker should face the calibration mic, and there should be no obstruction between the speakers and the calibration mic.
Calibration mic
12 Press C/c to select [YES].
Note
•Make sure that the headphones are not connected to the unit. You cannot operate following Steps with the headphones connected.
13 Press
.
[AUTO CALIBRATION] starts. Be quiet during the measurement.
Note
•Loud test sound is output when [AUTO CALIBRATION] starts. You cannot turn the
volume down. Give consideration to children and neighbors.
•Avoid being in the measurement area and making noise during the measurement (which takes about 3 minutes), as it may interfere with measurement.
14 Unplug the calibration mic and press C/
cto select [YES].
Note
•The environment of the room in which the system is installed may affect measurements.
•If measurement fails, follow the message then retry [AUTO CALIBRATION].
15 Press
.
Quick Setup is finished. All connections and setup operations are complete.
To quit the Quick Setup
Press DISPLAY in any Step.
Tip
•If you change the position of the speakers, reset the speaker settings. See “Getting Optimal Surround Sound for a Room” (page 78) and “Calibrating the Appropriate Settings Automatically” (page 79).
•If you want to change any of the settings, see “Using the Setup Display” (page 52).
To recall the Quick Setup display
1 Press FUNCTION +/– repeatedly until
“DVD” appears in the front panel display.
2 Press DISPLAY while the system is in stop mode.
The Control Menu display appears on the TV screen.
3 Press X/x to select 
[SETUP], then press
.
The options for [SETUP] appear.
94( 99)
1( | 1) | DVD VIDEO |
T | 0: 01: 08 |
|
CUSTOM
CUSTOM
QUICK