6)Clean only with dry cloth.

7)Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8)Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9)Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10)Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11)Only use attachments/accessories specified by the manufacturer.

12)Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

13)Unplug this apparatus during lightning storms or when unused for long periods of time.

14)Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

Precautions

On power sources

•AC power cord (mains lead) must be changed only at the qualified service shop.

•The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall

outlet (mains), even if the unit itself has been turned off.

•Install this system so that the AC power cord (mains lead) can be unplugged from the wall socket immediately in the event of trouble.

Note on power cord plug shapes (Saudi Arabian model only)For AC 220 V wall sockets

Make sure that the 13 A 3-pin plug (Type BF) is securely attached to the power cord. (The 13

A3-pin plug is attached when shipped from the factory.)

For AC 127 V wall sockets

1Remove the 13 A 3-pin plug using a screwdriver.

2Attach the supplied parallel blade plug (Type A).

3GB