Calibrating the
Appropriate Settings
Automatically
[AUTO CALIBRATION]
D. C. A. C. (Digital Cinema Auto Calibration) can set the appropriate surround sound automatically.
Note
•The system outputs a loud test sound when [AUTO CALIBRATION] starts. You cannot turn the volume down. Give consideration to children and neighbors.
•Make sure that the headphones are not connected to the unit. You cannot operate the following Steps with the headphones connected.
1 Press FUNCTION +/– repeatedly until
“DVD” appears in the front panel display.
2 Press 
DISPLAY while the system is in stop mode.
The Control Menu display appears on the TV screen.
3 Press X/x to select 
[SETUP], then press 
.
The options for [SETUP] appear.
4 Press X/x to select [CUSTOM], then press 
.
The Setup Display appears.
5 Press X/x to select [AUDIO SETUP], then press 
.
The options for [AUDIO SETUP] appear.
6 Press X/x to select [AUTO
CALIBRATION], then press 
.
The options for [AUTO CALIBRATION] appear.
7 Connect the calibration mic (supplied)
to the A.CAL MIC jack on the front panel
Set up the calibration mic at the ear level using a tripod, etc. (not supplied).
The front of each speaker should face the calibration mic, and there should be no
obstruction between the speakers and the calibration mic.
Calibration mic
Operations Other
8 Press C/c to select [YES].
9 Press
.
[AUTO CALIBRATION] starts. Be quiet during the measurement.
Note
•Avoid being in the measurement area and making noise during the measurement (about 3 minute), to avoid measurement failure. During the measurement, test signals are output from the speakers.
•The environment of the room in which the system is installed may affect measurements.
•If an error message appears, follow the message, then select [YES].
An error message appears when:
–the headphones are connected to the unit.
–the calibration mic is not connected.
–front speakers are not correctly connected.
–surround speakers are not correctly connected.