
Messages
Various messages appear on the screen. Check the corresponding descriptions in the following list to correct the problems.
General
Message | Cause and/or Corrective Actions |
|
|
USB Connection Error | A USB device is not connected correctly. |
| c Connect correctly (p. 18). |
|
|
USB Communication Error | • An invalid USB device is connected. |
| • The connection was interrupted by the USB device. |
|
|
The Connected USB Device | An incompatible USB device is connected. |
is not Compatible |
|
|
|
Bluetooth Connection Error | • The Bluetooth device is too far from your camcorder. |
| • The Bluetooth device is busy. |
|
|
Bluetooth | Register the Bluetooth device again (p. 23). |
Authentication Error |
|
Check the Certified Status |
|
|
|
Bluetooth | • The entered passkey was not correct. |
Registration Error | • The passkey transmission failed. |
Check the Passkey |
|
|
|
Bluetooth Communication | • The Bluetooth device is turned off. |
Disconnected | • The Bluetooth device is too far from your camcorder. |
| • The Bluetooth device is not connectable. |
|
|
Bluetooth | No Bluetooth devices are registered. Register the Bluetooth device |
Connection Error | (p. 23). |
Select Bluetooth Device |
|
|
|
PPP Authentication Error | Your ID or password entered on the PPP screen during manual |
Check ID or Password | setup may be wrong (p. 33). |
|
|
Phone Line Disconnected | Check the connection status. |
|
|
Connection Error | • The telephone number entered on the PPP screen in manual setup |
No Response From PPP Server | may be wrong. |
| • The Modem unit setup on the Network Options screen is wrong. |
|
|
Connection Error | Check that the communication device is connected to the telephone |
Check Phone Line | line. |
|
|
Low Battery | The remaining power of the battery pack is not enough. Change the |
| battery pack or use the AC Adaptor. |
|
|
Profile Error | Check the setup. If the settings were cleared, set up again referring to |
Reset Profile | your Setup memo (p. 110). |
|
|
Unable to Gain IP Address | IP address is not obtained automatically. The setting may be wrong |
| or the server may be down. |
|
|
Memory Error | Exit the network function, then enter the network function again. |
|
|