Sony DPP-EX50 manual 111

Symptom	Check	Cause/Solutions
The date cannot	• Is “Date Print” set to	cSet “Date Print” in the SET UP menu to
be printed.	“On”?	“On.” (.page 62)
	• Does the image support	cThe “Date Print” function of this unit
	DCF?	supports an image that is compatible
		with the DCF standards.
The date is	• Is “Date Print” set to	cSet “Date Print” in the SET UP menu to
printed	“Off”?	“On.” (.page 62)
unintentionally.
	• Was the date saved with	cChange the camera settings.
	the image when it was
	shot with the digital
	camera.
The image cannot	• Did you set “Borders” in	cSet “Borders” to “No” by selecting
be printed fully	the SET UP menu to		.	page 61)
	“Yes”?	Menu - SET UP - Borders. (
in the print
range.
	• Do you feed the print	cPlace the print paper in the direction of
	paper in the correct	the arrow. (.page 16)
	direction?
	• Is the aspect ratio of the	cDepending on the type of digital camera
	image correct?	used, the aspect ratio of the recorded
		image differs, so the image may not be
		printed covering the entire printable
		area.
					Troubleshooting
sides.	• Is the image edited and	on both sides of a print. To print without
Even if I set		cWhen you edit and save an image in the
“Borders” to	saved with “Borders” set	postcard or 3.5 x 5 inch size, it is saved as
“No,” the image	to “Yes.”	a print image including the blank areas.
is printed with		Even if you print it with “Borders” set to
borders on both		“No,” you cannot eliminate the borders
		borders, edit and save an image with
		“Borders” set to “No.” (.page 61)
Only part of an	• Did you set “Borders” in	cSet “Borders” to “Yes” to print the whole
image is printed.	the SET UP menu to “Yes”?	.	page 61)
		area of an image. (

111 GB