Setting the COMMAND MODE selector
Set COMMAND MODE on the remote commander to the same position as that on the VCR (both switches are set to “VTR4” at the factory.) Change the settings, however, in the following cases:
•If you use two or more Sony VCRs: Change the setting of each VCR in order to prevent accidental operation caused by overlapping of commander signals.
•To control another Sony VCR with the remote commander supplied with this VCR: Set COMMAND MODE on the other VCR to the same position as that on the remote commander supplied with this VCR.
•To control this VCR with the remote commander supplied with the other Sony VCR: Set COMMAND MODE on the remote commander supplied with the other VCR to the same position as that on this VCR.
Tips
•If you set the COMMAND MODE on the operation panel to “OFF,” you can no longer control this VCR from any other Sony remote commander.
•If the other Sony VCR does not have a COMMAND MODE switch, use the following settings:
VTR 1: For Sony Betamax format VCRs
VTR 2: For Sony 8 mm format VCRs
VTR 3: For Sony VHS format VCRs
To change the settings of COMMAND MODE on the remote commander
To change to VTR1 – VTR3
1 2 3
VTR
4 5 6
Set to the left.
To change to VTR4 – VTR6
1 2 3
VTR
4 5 6
Set to the right.
To change the settings of COMMAND MODE on the VCR
To change to VTR1 – VTR3
Set to the left.
Note
Setting of the COMMAND MODE selector works on the CONTROL S jack as well as the buttons on the remote commander.
|
| OFF |
| ||
|
|
|
| ||
1 | 4 | ||||
2 |
|
| 5 | ||
3 |
|
| 6 | ||
To change to VTR4 – VTR6
Set to the right.
OFF
14
2
5
36
Index to Parts and Controls | 17 EN |
|
|