Notes
•Do not change the counter display during insert editing. Editing may not function accurately.
•Insert editing cannot be made on a blank portion of the tape. When a blank is detected, the VCR stops editing.
•If you record on the beginning part of the tape, or on the part just after the unrecorded portion, the first part of recording may be dropped.
•After pressing STEREO 1 or 2 INSERT, it may take up to 7 seconds for the sound to switch to the source tape. You cannot start recording until the sound switches.
You can also insert audio/video from a VCR without a LANC jack, and audio from a cassette recorder or a microphone.
If you have to insert picture or sound into the master tape, make a work tape using the duplicate function on this VCR, and use the work tape for editing operations.
1 Press COUNTER SELECT so that the tape counter appears.
2 Locate the end point of the scene to be recorded over.
1Press (, then locate the recording end point with the jog dial or shuttle ring.
2Press COUNTER RESET at the end point.
3 Locate the start point of the scene to be recorded over.
Locate the beginning of the scene to be recorded over with the jog dial or shuttle ring.
4 [In case of video insert only] Press VIDEO INSERT.
The indicator lights.
[In case of audio insert only]
Press STEREO 1 INSERT or STEREO 2 INSERT as follows:
When you record from DV input
Press both STEREO 1 INSERT and STEREO 2 INSERT. You cannot replace stereo 1 track or stereo 2 track only.
When you record from LINE inputs
–To record in 16bit audio (Fs48k),
press both STEREO 1 INSERT and STEREO 2 INSERT.
–To record in 12bit audio (Fs32k) on the stereo 1 track, press STEREO 1 INSERT.
–To record in 12bit audio (Fs32k) on the stereo 2 track, press STEREO 2 INSERT.
[In the case of simultaneous audio/video insert] Press VIDEO INSERT to prepare for video insert and press STEREO 1 INSERT or STEREO 2 INSERT to select the track to replace.
(continued)
Editing 47 EN