![](/images/backgrounds/209458/209458-14426x1.png)
Overview 1 Chapter
Location and Function of Parts
3Battery attachment interfaceAttach a battery pack or an
For information about fitting a battery pack or an AC adaptor, see “Power Supply” (page 46). For information about attaching a synthesized tuner, see “Connecting to Audio System” (page 39).
i.LINK |
| |
cable (DV | Binding | |
connecting | ||
tie | ||
cable) | ||
|
To use the camcorder with an AC power supply, connect an optional
5AUDIO IN
Connect a microphone or other external audio equipment.Set the input selection switches as shown below according to the microphone or equipment.
MIC+48V ON (right position): For connecting to aNote
If this position is selected for a microphone other than
MIC (center position): For connecting any microphone other than
LINE (left position): For connecting an external audio signal source such as a stereo amplifier.
6WRR (synthesized tuner) connector
For information about attaching a synthesized tuner, see “Connecting to Audio System” (page 39)
7Cable clampFasten an i.LINK cable (DV connecting cable) to the clamp using the supplied binding tie so that the plug is not pulled out.
Connect to the DV input connector of an external VCR.
Notes
•This connector will not work as an input connector.
•When an external equipment, such as VCR, is connected to this connector, the ClipLink and the audio
This connector supplies power for a
Notes
•This connector always outputs the signals from the camera. It is impossible to output the playback video of the internal VCR.
•A camera control unit (CCU) cannot be connected to this connector.
•The image size on the viewfinder or on the screen of the
If an excessive current flows in the internal circuits, the internal circuit breaker shuts off the power supply.Push this button after eliminating the cause of the excessive current.
26 Chapter 1 Overview