Using SetupNavi and SetupLog

The SetupNavi function records a setting of the setup menu and setup files onto a tape, so that the same settings can be called up and used again or copied to another camera.

The SetupLog function records a camera setting every few seconds at shooting and displays the recorded data in the viewfinder during playback.

Note on using an RCP-TX7/RM-M7G Remote Control Unit

When an RCP-TX7/RM-M7G is connected to the camcorder, you can use neither the SetupNavi function nor the SetupLog function.

To make it possible to use these functions, power OFF the camcorder after disconnecting the RCP-TX7/RM- M7G, then power ON the camcorder again.

Setting Up the Camera Using Data Recorded on Tape

The procedure to replace camera’s menu settings with settings recorded onto video tape is described here.

1 Insert the cassette onto which the data was recorded. Set the SETUP switch to FILE, then set the POWER switch to ON while holding down the MENU dial.

Advanced menu page 1 appears.

mPAGE1 (NEXTm$ PREVm4)

ALL RESET

(YESmPUSH)

EXIT MENU (YESmPUSH)

2 Turn the MENU dial until advanced menu page 14 appears.

For details of menu operation, see “Advanced Menu Operations” (page 86).

mPAGE14(NEXTm$ PREVm4)

SETUP NAVI TAPE m CAMERA RECALL DATA

(YESmPUSH)

EXIT MENU (YESmPUSH)

NO TAPE” is displayed if you neglected to load a cassette.

3 Move the cursor to RECALL DATA with the MENU switch to call up the data recorded on the tape. (Press the MENU switch to cancel.)

The tape is rewound and playback starts. The display changes as follows and the call up operation begins.

PLAY

PAGE14(NEXTm$ PREVm4)

SETUP NAVI TAPE m CAMERA

mCANCEL TO RECALL (YESmPUSH)

SETUP NAVI

Name of data

ABCDEFGHIJ

EXIT MENU (YESmPUSH)

being called up

 

To abort the call up operation while in progress

Press the MENU dial.

After the data has been read, the following display appears.

PAGE14(NEXTm$ PREVm4)

SETUP NAVI TAPE m CAMERA

mSURE TO RECALL (YESmPUSH)

EXIT MENU (YESmPUSH)

4 Press the MENU dial.

The previous menu settings are overwritten by the data recorded on the tape.

PAGE14(NEXTm$ PREVm4)

SETUP NAVI

TAPE m CAMERA

mDONE

EXIT MENU (YESmPUSH)

5 Change the menu settings if necessary.

Chapter 4 Viewfinder Screen Indications and Menus 99

Menus and Indications Screen Viewfinder 4 Chapter