Perform step 1 (page 53) in “ Recording on the Internal VCR” .
Insert the cassette containing the previous recording.

Shooting 3 Chapter

Back Space Editing

This section describes the steps for recording several scenes continuously.

1 Follow steps 1 to 5 (pages 53 to 55) in the procedure “ Recording on the Internal VCR” to begin recording.

To continue the time code that has been recorded on the tape, set the TC mode switch 2 to R-RUN in step 3 (page 54).

For details of time codes, see “Setting the Time Code Value” on page 64.

2 When you have finished recording a scene, press the VTR button on the camcorder or lens.

This pauses the recording operation.

Note

Do not do any of the following before the next scene is shot as it will interrupt the recording (the recording will not be continuous).

•Remove the cassette.

•Transport the tape (play, rewind, fast forward). •Press the STOP button.

•Replace the battery when the camcorder is powered.

3 When you are ready to shoot the next scene, press the VTR button on the camcorder or lens again.

This restarts the recording operation.

4 Repeat steps 2 and 3 for each scene to be shot.

Operation

Step

 

 

Restart an

See next section “Starting Back

interrupted recording

Space Editing at Any Tape Position”.

(see step 2 above)

 

 

 

Check the recorded

See “Checking the Recorded

contents

Contents Immediately After Shooting

 

— Recording Review” on page 61.

 

 

Stop recording

Press the VTR button on the

 

camcorder or lens, then press the

 

STOP button.

 

 

If there is a long period before shooting the next scene

Once put the camcorder into recording pause mode, it waits a certain (user-definable) period of time and then automatically switches to standby-off mode. When the camcorder is in standby-off mode, it takes time for the recording to start after pressing the VTR button.

For details on setting the timeout value for automatic switching to standby-off mode, see “Menu 207 Setting Standby-On Period” on page 106.

Starting Back Space Editing at Any Tape Position

This section describes the steps for insert a new scene at any desired position on the tape.

The following steps can also be used to restart recording after an interruption has occurred.

1

2

3 Perform steps 3 and 4 (pages 54 and 55) in “ Recording on the Internal VCR” .

To continue from the last time code of the previous recording, set TC mode switch 1 to REGEN.

For details about time codes, see “Setting the Time Code Value” on page 64.

4 Press the PLAY button.

The recorded contents are displayed on the viewfinder screen.

Operation at playback

Step

 

 

Fast forward the tape

Press the F FWD button.

 

 

Rewind the tape

Press the REW button.

 

 

58 Chapter 3 Shooting