7-8 Adjusting the

7-9 Putting on the Rain

Shoulder Pad Position

Cover (Not Supplied)

Camcorder the Up Setting 7 Chapter

You can shift the shoulder pad from its center position (factory setting) backward by up to 10 mm (3/8 inch) or forward by up to 25 mm (1 inch). This adjustment helps you get the best balance for shooting with the camcorder on your shoulder.

Proceed as follows:

1,3

 

Bottom

2

Shoulder pad

 

Adjusting the shoulder pad position

1 Raise the lever in the center of the shoulder pad to unlock the shoulder pad.

2 Slide the shoulder pad backward or forward until it is in the most convenient position.

3 Bring down the lever to lock the shoulder pad in the selected position.

Attach the rain cover (part number 3-191-064-02) as illustrated below. You can insert and remove cassette tapes, operate various switches and controls, and mount the camcorder on the tripod adaptor with the rain cover attached.

When a shoulder

When you use a

belt is not used,

shoulder strap,

cover the holes

use these holes.

on the rain cover

For details, see

with caps.

the following

 

diagram.

Rear

Front

Velcro tape

Drawstring

Pass the shoulder strap post clearly through this hole on the rain cover.

Insert the viewfinder barrel here with the eyecup out and fasten the drawstring around the eyecup.

Drawstring

Velcro tape

Velcro tape

118

Adjusting the Shoulder Pad Position / Putting on the Rain Cover (Not Supplied)