1 Chapter
The necessary settings are made using the NETWORK menu displayed on the viewfinder or monitor screen.
iDC OUT 12V (DC 12V power output) connector DC 12V power can be fed to an accessory.
jDC OUT 24V (DC 24V power output) connector DC 24 V power can be fed to an accessory.
Use as reference for focusing. The same reference mark is also provided at the right of the riser plate (page 13).
For actual measurement of the distance from a subject, you can fix the end of a tape measure to the hook.
Overview
eSafety release tab
fAccessory clamp lever
gLock release knob
hAccessory mount lever
1
aAssignable buttons 1, 2, 3
1 2 3
FILTER
1 CLEAR | 1 |
2 1/4 ND ND 3 1/16ND 4 1/64ND
5 CAP
A 5600K
B 3200K
CCC 4300K D 6300K E 1/2 ND
|
| LOCK VF MENU/DISPLAY CANCEL/STATUS |
|
bLOCK switch |
|
| Display/menu operation block |
|
|
| |
cRUN button and indicator |
|
| |
d4/AUTO BLK BAL switch | RUN |
|
|
AUTO |
|
| |
| 4 |
|
|
| BLK | PAGE SET | iMemory stick section |
| BAL | ||
|
|
|
PRO
jFocus reference mark
kTripod receptacles (bottom)
Riser plate
You can assign various functions to these buttons, using the subdisplay on the left panel or on the assistant panel or the menu displayed on the viewfinder or monitor screen. The ND filter selection function is assigned to button 1 and the CC filter selection function to button 2 at the factory. (No function is assigned to button 3.)
For details, see
To start/stop recording on the
The firmware of the
Push the switch downward to the AUTO BLK BAL side to start the auto black balance adjustment.
The function activated by pressing the switch upward to the 4 side can be selected using the subdisplay on the left panel or on the assistant panel or the menu displayed on the viewfinder or monitor screen.
For details, see
eSafety release tab f Accessory clamp lever g Lock release knob h Accessory mount lever
For mounting/unmounting an
12 | Locations and Functions of Parts |
|
|