Inserting batteries into the remote

Insert two R6 (size-AA) batteries in the RM-AAU057 Remote Commander. Observe the correct polarity when installing batteries.

Notes

Do not leave the remote in an extremely hot or humid place.

Do not use a new battery with old ones.

Do not mix manganese batteries and other kinds of batteries.

Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction.

If you do not intend to use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.

When you replace the batteries, the remote buttons may be reset to their factory settings. If this happens, reassign the buttons again (page 48).

When the remote no longer operates the receiver, replace all the batteries with new ones.

7:Calibrating the appropriate settings automatically

(AUTO CALIBRATION)

This receiver is equipped with DCAC (Digital Cinema Auto Calibration) Technology which allows you to perform automatic calibration as follows:

Check the connection between each speaker and the receiver.

Adjust the speaker level.

Measure the distance of each speaker from your listening position.

Measure the frequency characteristics.*

*The measurement result is not utilized for signals with a sampling frequency of more than 96 kHz.

The DCAC is designed to obtain proper sound balance in your room. However, you can adjust the speaker levels manually according to your preference. For details, see

“8: Adjusting the speaker levels (TEST TONE)” (page 26).

22US