HDMI

The volume turns down when the output method changes from the TV speaker to the speakers connected to the receiver.

•The Volume Limit function is working. For details, see “Using the Volume Limit function” (page 44).

The source sound input to the HDMI jack on the receiver is not output from the receiver or the TV speaker.

•Check the setting of CONTROL FOR HDMI in the SET HDMI menu (page 31).

•Check the HDMI connection (page 18).

•You cannot listen to the Super Audio CD by connecting HDMI.

•Depending on the playback component, you may need to set up the component. Refer to the operating instructions supplied with each component.

The source image input to the HDMI jack on the receiver is not output from the TV.

•Check the HDMI connection (page 18).

•Depending on the playback component, you may need to set up the component. Refer to the operating instructions supplied with each component.

The control for HDMI function does not work.

•Check the HDMI connection (page 18).

•Make sure “CONTROL FOR HDMI” is set to “CTRL ON” in SET HDMI menu.

•Make sure the connected component is compatible with the Control for HDMI function.

•Check the Control for HDMI settings on the connected component. Refer to the operating instructions of the connected component.

•Repeat the procedures of “Preparing for the “BRAVIA” Sync” if you change the HDMI connection, connect/disconnect the AC power cord, or there is a power failure (page 42).

No sound is output from the receiver and TV speaker while using the System Audio Control function.

•Make sure the TV is compatible with the System Audio Control function.

•If you cannot listen to the sound of a component connected to the receiver

–Select the appropriate input when you want to watch a program on a component connected via HDMI connection to the receiver.

–Change the TV channel when you want to watch a TV broadcast.

–Select the component or input you want to watch when you watch a program on the component connected to the TV.

Refer to the operating instructions of the TV on this operation.

Tuner

The FM reception is poor.

•Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna as shown below. If you connect the receiver to an outdoor antenna, ground it against lightning. To prevent a gas explosion, do not connect the ground wire to a gas pipe.

Outdoor FM antenna

Receiver

ANTENNA

AM

Ground wire (not supplied)

To ground

54US