4 Press to start the measurement.

Measurement starts in 5 seconds. While the time is counting down, stand away from the measurement area to avoid measurement error.

The measurement process will take approximately 30 seconds to complete.

The table below shows the display when measurement starts.

Measurement for

Display

Speaker existance

TONE

 

 

Speaker gain, distance,

T.S.P.

frequency response

 

 

 

Subwoofer gain and distance

WOOFER

 

 

Note

If “CHK MIC” appears, you cannot perform the Auto Calibration. Connect the calibration mic, then restart the Auto Calibration.

Tips

•When Auto Calibration starts:

–Stand some distance from the speakers and the listening position to avoid measurement failure. This is because test signals are output from the speakers during measurement.

–Avoid making noise to get a more accurate measurement.

•The Auto Calibration function will be canceled when you do the following during the measurement process:

–Press ?/1 or MUTING.

–Press input buttons on the remote or INPUT SELECTOR on the receiver.

–Change the volume level.

Confirming/saving the measurement results1 Confirm the measurement result.

When the measurement ends, a beep sounds and the measurement result appears on the display.

Measurement Display

Explanation

result

 

 

 

 

 

When the

SAVE

Proceed to step

measurement

 

2.

process

 

 

completes

 

 

properly

 

 

 

 

 

When the

ERROR

See “When

measurement

XXXX

error codes

process fails

 

appear” (page

 

 

25).

2 Press V/v repeatedly to select the item. Then, press .

Item

Explanation

SAVE

Saves the measurement

 

results and exits the setting

 

process.

 

 

WRN CHK

Displays warning

 

concerning the

 

measurement results. See

 

“When you select “WRN

 

CHK”” (page 25).

 

 

DIST

Displays the measurement

 

result for speaker distance.

 

 

LEVEL

Displays the measurement

 

result for speaker level.

 

 

EXIT

Exits the setting process

 

without saving the

 

measurement results.

 

 

Note

After “SAVE” is displayed for 50 seconds, the measurement result is saved automatically, without the need to save the procedure.

3 Save the measurement result.

Select “SAVE” in step 2.

The measurement results are saved.

24US