Radio stations cannot be tuned in.
•Check that the antennas are connected securely. Adjust the antennas and connect an external antenna, if necessary.
•The signal strength of the stations is too weak (when tuning in with automatic tuning). Change to monaural reception (page 39).
•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 39).
Error messages
If an error message appears while you perform Auto Calibration, see “When error codes appear” (page 25) to solve the problem.
If you are unable to remedy the problem using the troubleshooting guide
Clearing the receiver’s memory may remedy the problem (page 21). However, note that all memorized settings will be reset to their factory settings and you will have to readjust all settings on the receiver.
Remote control
The remote does not function.
•For receiver operation, you can only use the DISPLAY button when the TUNER input is selected.
•Point the remote at the remote sensor on the receiver.
•Remove any obstacles in the path between the remote and the receiver.
•Replace all the batteries in the remote with new ones, if they are weak.
•Make sure you select the correct input on the remote.
If the problem persist
Consult your nearest Sony dealer. Note that if service personnel changes some parts during repair, these parts may be retained.
Reference sections for clearing the receiver’s memory
To clear | See |
All memorized settings | |
|
|
Others
The ACTIVE STANDBY lamp is flashing.
•The receiver is in protection mode. Turn off the receiver and turn it on again.