Notes
•To playback the picture recorded in HDV format when you connect the monitor using a component video cable, set [COMPONENT] of [VIDEO OUT] in [IN/OUT REC] menu according to your monitor (page 47). When the picture recorded in DVCAM/ DV format is played back, only a picture with a quality equivalent with DVCAM/DV format of 480i (NTSC) or 576i (PAL) is output via COMPONENT OUT jacks regardless of [COMPONENT] setting.
•For details on output level from COMPONENT OUT jacks, see “Specifications” (page 75).
•To change the output level from COMPONENT OUT jacks, see [480i LEVEL] in [IN/OUT REC] menu (page 48).
•If you connect the input connectors of the unit to the output connectors of a monitor, a humming noise may be generated or the image may be distorted. If these phenomena occur, use INPUT SELECT switch to select a signal that is not being input or disconnect the cables.
•When you play back an
with copyright protection to HDV/DV jack, pictures may be output in either 480i (NTSC) or 576i (PAL) format regardless of the setting of [COMPONENT] of [VIDEO OUT] in [IN/OUT REC] menu.
•The unit cannot up convert DVCAM/DV recordings to HDV at output.
Connecting the unit to a monitor equipped with an i.LINK jack
The video and audio signals are sent with hardly any degradation, enabling
i.LINK cable (not supplied)
i.LINK jack
Monitor with an i.LINK jack
: Signal flow
Notes
•Be sure that you set [HDV/DV SEL] in [IN/OUT REC] menu to [AUTO] (default setting) before connecting the video equipment to the unit with the i.LINK cable. If you change the setting after connecting the i.LINK cable, the monitor may not recognize the video signal correctly (page 46).
•To connect the unit to a monitor equipped with an i.LINK jack, you may need to adjust the monitor settings so that it recognizes the unit.
For details, refer to your monitor’s instruction manual.
•When i.LINK is connected, the unit cannot output video or audio only.
(Continued)
Recording and Playback 2 Chapter
Chapter 2 Playback and Recording | 25 |