Recording

Symptom

Cause/Remedy

No picture is output via HDV/DV jack.

t Reconnect the i.LINK cable (not supplied).

•INPUT SELECT switch is set to a position other than HDV/DV. t Set the switch to HDV/DV.

tSet [HDV/DV SEL] in [IN/OUT REC] menu correctly.

About the audio level setting:

Confirm the level of the sound output from the player by referring to the player’s

• You do not know how to adjust the input

instruction manual.

level.

If you are not clear about the player’s output level, try the following procedures.

• The recorded level is too low.

• Set [AUDIO AGC] in [AUDIO SET] menu to [OFF], set [AUDIO REC LV] to [0

• The recorded sound is distorted.

dB], and play back the tape which you intend to use for playback. When the

 

playback audio level is at its maximum, if the audio levels meters exceed 0 dB,

 

set [AUDIO REC LV] to [–6 dB]. When the volume is too low, set [AUDIO REC

 

LV] to [+6 dB]. The recorded sound at the portion where the meters exceed 0 dB

 

will be distorted.

 

For details of the acceptable maximum input level, see page 50.

 

 

No sound or undesired sound is output

t When the audio mode is 32 kHz (4-channel), set [AUDIO MIX] in [AUDIO

from AUDIO jacks in OUTPUT.

SET] menu to [CH1, CH2]. When the audio mode is 32 kHz (4-channel) on the

 

unit, audio is recorded in channel 1/2.

 

If an i.LINK cable is connected when you t Use the correct setting for [HDV/DV SEL] in [IN/OUT REC] menu in

editing, the monitor does not display any

accordance with the equipment to be connected.

image.

 

 

 

EE sound is not output.

t If the audio mode is set to 32 kHz (4-channel), Set [AUDIO MIX] to [CH1,

 

CH2] or [MIX].

 

 

EE picture and EE sound are not output.

• [EE/PB SEL] in [IN/OUT REC] menu is set to [PB].

 

t Set [EE/PB SEL] to [EE].

 

• The setting of INPUT SELECT switch does not match the signal input.

 

t Set the switch according to the signal input.

 

• With an analog connection, the current setting of [60i/50i SEL] in [OTHERS]

 

menu is not appropriate.

 

t Set it to the appropriate position for the device you are using.

Maintenance 5 Chapter

Chapter 5 Maintenance

61