Screen Size/Shift The “Screen Size/Shift” option allows you to adjust the size and position of the picture for each screen format.

To do this:

1After selecting the option, press .

2Press or to select the option and press . Then Press //

or to adjust the size and position of the picture.

V Size (Vertical Size):

Press to enlarge the Screen Size vertically.

Press to shrink the Screen Size vertically.

Screen Shift

H Shift (Horizontal Shift):

Press to move the screen to the left.

Press to move the screen to the right.

V Shift (Vertical Shift):

Press to move the screen up.

Press to move the screen down.

Reset:

Select OK to reset to the factory settings.

•Screen Size/Shift cannot be adjusted for a HD signal connected to the Y, PB/CB, PR/CR

jacks of 5 and the “Memory Stick” input.

•H Shift (Horizontal Shift) can only be adjusted for an RGB input signal connected to

the Scart Connector 1/, 2/ or 4/.

•When “Screen Format” is set to “4:3” or “Wide,” V Size (Vertical Size) and V Shift (Vertical Shift) cannot be adjusted for the video input signal from connected equipment.

Adjust Pixel

The “Adjust Pixel” option allows you to adjust the picture from RGB

 

equipment.

To do this:

1After selecting the option, press .

2Press or to select the following option.

Auto Adjust:

Select OK to automatically make the best picture for the input signal. Note that it may not be adjusted perfectly depending on the input signal condition or picture pattern. In this case, perform Auto Adjust again or adjust manually as below.

Dot phase:

Adjust between 00-100 when part of a displayed text or image is not clear.

Total H Pixel (Total Horizontal Pixel):

Adjust when the general picture is not completely clear.

Reset:

Reset to the factory settings.

Adjust Pixel is only available for an RGB input signal connected to the PC connector.

32Menu System