— Input Monitor
You can monitor the signal being input to the MD deck without recording it.
This lets you adjust the recording level of analog sources.
2 1
| • | • • |
§ | • | • |
• | • | |
EJECT | • | • |
=SELECTOR + | · | |
r REC | ||
| 0 | ) |
| p |
|
§ |
|
|
OPEN/CLOSE |
|
|
=SELECTOR +
·
1 Press
§
EJECT to remove the0 p )MD.
2 Press rREC.
If the input signal is analog, the ANALOG IN indicator lights up, and
If the input signal is digital,
When you edit recorded tracks, there is no need for copying the MD.
•To change the order of tracks
Use the Move Function (see page 47) to change the track numbering.
•To erase recordings
Use the Erase Function (see page 45). This lets you erase a single track one by one or all tracks at once.
•To locate the beginning of a specific phrase
Use the Divide Function (see page 48) to add track numbers. This lets you find your favorite phrases quickly and play them repeatedly.
•To create a medley by combining several phrases
Use the Divide and Erase Functions to erase unwanted portions, then put several phrases into a single track using the Combine Function (see page 49).
By using the editing functions in this way, you can create original MD albums.
Note on editing an MD
The MD editing is complete only after all the editing information is entered to TOC at which point TOC stops flashing and goes out. Be careful not to disconnect the mains lead or move the deck before this point. Before disconnecting the mains lead, do the following:
–Remove the MD.
–Press SYSTEM POWER, to turn off the system.
44EN