If you run into any problem using this stereo system, use the following check list.
First, check that the power cord is connected firmly and the speakers are connected properly and firmly.
Should any problem persist, consult your nearest Sony dealer.
General
There is no sound.
•Rotate VOLUME clockwise. •The headphones are connected. •Connect the cords and cables properly.
Insert the plugs firmly.
There is severe hum or noise.
•A TV or VCR is placed too close to the stereo system. Move the system away from the TV or VCR.
“0:00” (for European model) or “12:00AM” (for other models) flashes in the display.
•A power interruption occurred. Set the clock and timer settings again.
The timer does not function.
•Set the clock correctly.
The indicators on the DAILY and REC buttons do not light even if you press them.
•Set the timer correctly.
The remote does not function.
•There is an obstacle between the remote and the system.
•The remote is not pointing in the direction of the system’s sensor.
•The batteries have run down. Replace the batteries.
There is acoustic feedback.
•Decrease the volume level. Move the microphone away from the speakers or change the direction of the microphone.
Speakers
Sound comes from one channel or unbalanced left and right volume.
•Check the speaker connection and speaker placement.
CD Player
The CD tray will not close.
•The CD is not placed properly.
The CD will not play.
•The CD is dirty.
•The CD is inserted with the label side down.
•Moisture condensation has built up. Remove the CD and leave the system turned on for about an hour until the moisture evaporates.
Play does not start from the first track.
•The player is in Program or Shuffle Play mode. Press CONTINUE so that “SHUFFLE” or “PROGRAM” disappears.
“OVER” is displayed.
•You have reached the end of the CD. Press 0(or =on the remote) to return.
“REPAIR!” is displayed.
•Consult your nearest Sony dealer.
MD Deck
only)
An incompletely inserted MD cannot be pulled out.
•Insert the MD completely, then press
§EJECT.
The inserted MD is pulled out.
•Insert the MD with the label side up in the direction of the arrow.
The controls do not work.
•The MD is dirty or scratched (“Disc Error” appears). Replace the MD with a new one.
70EN