Waking up to music (continued)

4 Set the time to start playback.

Turn MULTI CONTROLLER to set the hour, then press ENTER/NEXT.

The minute indication starts flashing.

Turn MULTI CONTROLLER to set the minute, then press ENTER/NEXT. “OFF” appears and the hour indication flashes again.

5 Set the time to stop playback following the procedure in step 4.

6 Turn MULTI CONTROLLER until the sound source you want appears.

The indications change as follows:

CD PLAY nTUNER nTAPE PLAY

nMD PLAY

7 Press ENTER/NEXT.

The start time, followed by the stop time and the sound source appears, then the original display appears.

8 Adjust the volume and turn off the power.

To change the setting

Start over from step 1.

To check the setting

Press DAILY to turn on the indicator. If the indicator is already lit, press the button once to turn off the indicator, then press it again.

The start time, followed by the stop time and the sound source appears, then the original display appears.

To cancel the timer operation

Press DAILY to turn off the indicator.

Tip (for DHC-MD77/EX77MD/EX770MD)

When you connect the optional TC-TX77/TX770 deck to the system with the audio bus cable (see page 12), you can activate the wake-up timer with the tape deck.

Notes

•Do not operate the system from the time the power turns on until the playback starts (about 40 seconds).

•If “OFF TIME NG !” appears, the timer-on and -off settings are the same. Change the time to turn off.

64EN