Sony Playing an MD

To stop recording

Press pon the tape deck or the CD player.

Tips

•Pressing SYSTEM POWER on the DHC-MD77/ EX77MD/EX770MD automatically turns on the TC-TX77/TX770 deck if you connect them to each other using the audio bus cable.

•If you want to record from the reverse side, press ªin step 6 so that “ªPLAY P {REC}” (for reverse side) appears.

•When you record on both sides, be sure to start from the front side. If you start from the reverse

side, recording stops at the end of the reverse side even though you select a.

•When you want to reduce the hiss noise in low- level high-frequency signals, press DOLBY NR repeatedly to select B or C before step 5. You cannot switch DOLBY NR during recording.

•If the tape reaches the end of its front side while dual-sided recording, the fadeout feature works so that a track is not abruptly cut off at the end of the tape (Fade Synchro). The track will be recorded again from the beginning on the reverse side. The Fade Synchro feature works during one-side recording, too.

•You cannot perform CD Synchro Recording by pressing the CD SYNC buttons on both the tape deck and the MD deck at the same time.

Use the CD Synchro Recording feature for a tape and record on an MD manually. This method is recommended since on the MD deck, you can erase the overlapping track recorded using the Fade Synchro feature just by specifying its track number (Erase Function).

Note

You cannot listen to other sources while recording.

Playing an MD

(DHC-MD77/EX77MD/EX770MD only)

You can play an MD just like a CD.

POWER VOLUME §EJECT 2

	•	• •
§	•	•
	•	•
EJECT	•	•
= SELECTOR +
r REC	·￿
	0	)
	p
§
OPEN/CLOSE
= SELECTOR +
	·￿
	0	)
	p

·	P	p	1 SELECTOR p 0/)
–	+
= +			P
· ·	P	p

= + =/+

ª· p

0 )

+	VOL (+/–)
–

1 Insert an MD.

With the arrow
pointing	•	•
§	•
toward the	·￿
deck	p
	0 )
With the label
side up

continued

Operations Basic

21EN