4 Turn MULTI CONTROLLER to tune in the desired preset station.

Turn counter- – MULTI CONTROLLER +

Turn clockwise

clockwise

(or press

(or press

PRESET + on

PRESET –

the remote)

on the remote)

for higher

for lower preset

preset

numbers.

numbers.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Frequency

Preset number

5 For DHC-MD77/EX77MD/ EX770MD:

Press rREC on the MD deck.

The MD deck stands by for recording.

For MHC-EX66/EX660 or the

TC-TX77/TX770 users:

Press DIRECTION repeatedly to select the side you want to record on (one side: Aor both sides: Åor

a), then press rREC on the tape deck.

The tape deck stands by for recording and “PLAY ·P {REC}” appears.

6 Turn REC LEVEL to adjust the recording level.

For details, see “Adjusting the recording level” on page 37 (DHC-MD77/ EX77MD/EX770MD) or “Recording on a tape manually” on page 52 (MHC-EX66/ EX660 or the TC-TX77/TX770 users).

7 For DHC-MD77/EX77MD/ EX770MD:

Press ·￿on the MD deck (or P on the remote).

For MHC-EX66/EX660 or the

TC-TX77/TX770 users:

Press Por ·on the tape deck.

Recording starts.

To stop recording

Press pon the MD deck or the tape deck.

Tips

•To record non-preset stations, press TUNING MODE repeatedly until “TUNING” appears in step 3 (European model) or press MANUAL in step 3 (other models), then turn MULTI CONTROLLER to tune in the desired station.

•If noise is heard while recording an AM radio program, move the AM antenna to reduce the noise.

Note on recording on an MD

The MD recording is complete only after all the recording information is entered to TOC at which point TOC stops flashing and goes out. Be careful not to disconnect the mains lead or move the deck before this point. Before disconnecting the mains lead, do the following:

–Remove the MD.

–Press SYSTEM POWER, to turn off the system.

Notes on recording on a tape

•If you want to record from the reverse side, press ª after pressing r REC on the tape deck in step 5 so that “ªPLAY P {REC}” appears.

•When you want to reduce the hiss noise in low- level high-frequency signals, press DOLBY NR repeatedly to select B or C before step 5. You cannot switch DOLBY NR during recording.

Operations Basic

27EN