masterpage:Right
filename[D:\WORKS\CD\3067951111\3067951111MVCCD200UC\02GB-
MVCCD200UC\09add.fm]
97
modelname1[MVC-CD200/CD300]
[3-067-951-11(1)]
Additionalinformation
Reinstall the USB driver when using Windows 98, Windows
98SE, Windows Me and Windows 2000 Professional
Performall steps without skipping.
TheTEXT mode
recording cannot be
properlyd one.
•Thesubject is not under even lighting situations.
tChangelighting.
•Themode dial is set t o S, A, M, or SCN.
tSetit to .
Yourcomputer does not
recognize your camera. •Thebattery level is low.
tUsethe AC power adaptor (page 13) .
•Thecamer a is turned off.
tTurnon the camera.
•TheUSB cable is not connected firmly.
tDisconnect the USB cable, and connect it again
firmly.Make sure that“US B MODE”is
displayedontheLCDscreen(page38).
•TheUSB co nnectors on your computer are
connectedto other equi pment besides the keyboard,
themouse , and your camera.
tDisconnect the USB cables except for the ones
connected to the keyboard, the mouse, and your
camera.
•TheUSB driver is no t installed.
tInstallthe USB driver (page 38).
•[USBCONNECT] is set to [PTP] in the setup
settings.
tSetit to [NORMAL] (page 86).
•Sincethe camera is connected to a computer with
theUSB cabl e before installing the USB driver, the
driveis not recognize d bythe c omputer.
tDeletethe drive which is not recognized, then
installthe USB driver. For details, seethe
procedurebelow.
1Turnon your computer and allow Windows to load.
2Connect the USB jack on the camera and the computer with the
supplied USB cable.
3Insert a disc.
4Connect the ACp ower adaptor to your camera and then to a wall
outlet(mains), and turn on the powerof your camera.
Symptom Cause and/or Solution
01cov.book Page97 Thursday, March8, 2001 4:59PM