Additional Information
Precautions
On safety
•Do not put any foreign objects in the USB cable connecting jack.
•Do not touch the optical pickup lens on the recorder and keep it clean. If you do so, the lens may be damaged and the recorder will not operate properly. To prevent dust from entering the recorder, make sure to keep the lid closed, except when inserting or taking out discs.
On power sources
•Use house current or rechargeable battery.
•Connect the AC power adaptor or the AC power cord to an easily accessible AC outlet. Should you notice an abnormality in the AC power adaptor or the AC power cord, disconnect it from the AC outlet immediately.
•The recorder is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the recorder itself has been turned off.
•If you are not going to use this recorder for a long time, be sure to disconnect the power supply (AC power cord or rechargeable battery). To remove the AC power cord from the wall outlet, grasp the adaptor plug itself; never pull the cord.
On the recorder
•Do not shake or strike the recorder. In addition to malfunctions and inability, this may render the disc unusable or data breakdown, damage or loss may occur.
•Do not get the recorder wet. When you use the recorder in the rain or under similar conditions, be careful not to get the recorder wet.
•Your recorder is designed for use between the temperatures of 0 °C and 40 °C (32 °F and 104 °F). Shooting in extremely cold or hot places that exceed this range is not recommended.
•After using your recorder at the seashore or other dusty locations, clean your recorder carefully. Otherwise, the salty air may corrode the metal fittings or dust may enter the inside of your recorder, causing a malfunction.
On heat build-up
Heat may build up in the recorder if it is used for an extended period of time. This, however, is not a malfunction.
On mechanical noise
The recorder gives off mechanical noise while operating, which is caused by the power- saving system of the recorder and it is not a problem.
On installation
•If you use the recorder at a place subject to static or electrical noise, the recording may not be properly done or the recorded data may be lost.
•Never use the recorder where it will be subjected to extremes of light, temperature, moisture or vibration.
•Never wrap the recorder in anything when it is being used with the AC power adaptor. Heat
Information Additional
75