NW-A805/A806/A808/NWZ-A815/A816/A818
Ver. 1.4
3-5. NAND BOARD, SVX SWITCH FLEXIBLE (PWB ASSY)
9sheet (NAND) 
3two screws (M1.4)
q; spacer (NAND)
qa NAND board
6 Remove three solders.
5 Lift up the NAND board.
4Turn up the LCD flexible board. 
2Lift up the
SVX swtch flexible (PWB assy).
1 two claws
7 insulating sheet
8 SVX swtch flexible (PWB assy)
– rear view –
Note: Follow the assembly procedure in the numerical order given.
Note: Route the lead wires as shown in the figure,
and solder them at the angle shown in the figure. |
|
SVX swtch flexible (PWB assy) |
|
Note: The soldering height |
|
should be less than 0.8 mm. |
|
lead wire (red) |
|
lead wire (gray) |
|
About 45° | lead wires |
| front cabinet assy |
About 45°
2 Holding the bent part,
rotate the SVX swtch flexible (PWB assy) by 3 or 4 turns in the arrow direction, and twist to bind the lead wires.
1 Bend the switch flexible board.
claw
LCD holder
claw
lead wire (black)
– rear view –
NAND board
3 Holding the bent part, push in the SVX swtch flexible (PWB assy) until it gets stuck by two claws of the front cabinet assy.
4 Push the lead wires completely into a space between front cabinet assy and LCD holder.
9
