To handle input signals as
Chapter | b DIGITAL AUDIO (AES/EBU) OUTPUT 1/2 and | |
3/4 connectors (BNC type) | ||
| ||
1 | These output AES/EBU format digital audio signals. The | |
1/2 connector corresponds to audio channels 1 and 2, and | ||
Overview | ||
the 3/4 connector corresponds to audio channels 3 and 4. | ||
| ||
| 5 Timecode input/output section |
1TIME CODE IN connector
2TIME CODE OUT connector
TIME CODE
IN OUT
aTIME CODE IN connector
Inputs SMPTE timecode generated by an external device.
bTIME CODE OUT connector
Outputs the following timecode, depending on the operating state of the unit.
During playback: Playback timecode
During recording: The timecode from the internal timecode generator or the timecode input to the TIME CODE IN connector.
Note
In
1 - AC IN connector
a
Connect to an AC power supply with the power cord (not supplied).
bPOWER (main power) switch
Press the + side to power on the unit. Press the a side to power off.
When using the unit, normally leave the POWER switch in the + (on) position, and use the on/standby switch on the front panel to switch the unit between the operating state and standby state.
Note
If you press the on/standby switch on the front panel while the unit is in the operating state, the unit saves its data and then enters the standby state (the on/standby indicator lights red). Before turning the main power off, always check to be sure that the unit is in the standby state, and then push the main power switch to the a side.
7External device connection section1CONTROL connector
2RS232C connector
3 REMOTE(9P) connector
RS232C | REMOTE(9P) |
CONTROL | S400 |
|
4Remote connector selector switch
5 S400 connector
6 U terminal
aCONTROL connector (minijack
bRS232C (serial interface) connector
Connect a computer or other device with a serial interface to control this unit from that device.
When you use this connector, set the remote connector selector switch to the RS232C side, and set INTERFACE
2 POWER switch
POWER
SELECT >REMOTE I/F in the setup menu to “9PIN/RS- 232C” (see page 94).
cREMOTE(9P) (remote control
To control this unit from a controller or VTR supporting the
20 Names and Functions of Parts