Sony PDW-F70 Editing Control Unit Settings, Remote Control Unit Settings, Using XLR Cables (Audio Cables), BVE-700/700A, To attach the ferrite core

SD video monitor

To composite video input connector

To analog audio input connector

12

		COMPOSITE		AUDIO		PDW-F70 (this unit, player)
		OUT		MONITOR
REF VIDEO INPUT		COMPOSITE OUT	AUDIO MONITOR	TIME	CODE		-AC IN
			R L	IN	OUT			POWER
						ANALOG HD INPUT
						Y/G	PB /R
	AUDIO INPUT		AUDIO OUTPUT	DIGITAL 1/2		3/4
1/3	2/4	1/3	2/4	AUDIO
				(AES/EBU)		PB /B	SYNS
				INPUT
				1/2		3/4
				OUTPUT
HDSDI INPUT	HDSDI OUTPUT SDSDI OUTPUT
	1	2	MONITOR		RS232C		REMOTE(9P)
								S400
				CONTROL

S400 4

DSR-2000A/2000AP (recorder)

i.LINK

VIDEO OUT 3
			MONITOR
(SUPER)	1		AUDIO
To composite		3
video input
connector

To analog audio input connector SD video monitor

1: 75Ω coaxial cable (not supplied)

2: Phono plug – stereo miniplug cable (not supplied)

3: Phono plug cable (not supplied)

4: i.LINK cable (not supplied)

DSR-2000A/2000AP	This unit’s (player) settings
(recorder) settings
i.LINK button: Lit	Remote control switch:
	REMOTE
SDTI/i.LINK button: i.LINK	Set the setup menu item
	INTERFACE SELECT
	>REMOTE I/F to “i.LINK” (see
	page 94).

For details about the settings of the DSR-2000A/2000AP, refer to the operating instructions for that unit.

Editing Control Unit Settings

When connecting an editing control unit to use with this unit, make the following settings.

BVE-700/700A

Set VTR constants as follows.

System	VTR CONSTANT 1
frequency
	1	2	3	4	5	6	7	8
30P/60I	A0	93	00	96	16	16	03	80
25P/50I	A1	93	00	7D	16	16	03	80
24P	A2	93	00	78	16	16	03	80

System	VTR CONSTANT 2
frequency
	1	2	3	4	5	6	7	8
30P/60I	0A	07	FE	00	80	5A	FF	5A
25P/50I	0A	07	FE	00	80	4C	FF	4B
24P	0A	07	FE	00	80	48	FF	48

Remote Control Unit Settings

You can control this unit from an RM-280 Remote Control Unit.

Connect this unit to the RM-280 with a 9-pin remote control cable (not supplied), and make the settings in the following table.

RM-280 settings	Settings on this unit
EDITOR/REMOTE	Setup menu item INTERFACE
CONTROL: REMOTE	SELECT >REMOTE I/F (see
CONTROL	page 94): 9PIN/RS-232C
Setup menu item 19	Remote control switch: REMOTE
FNC MODE: XDCAM
	Remote connector selector
	switch: REMOTE(9P)

Using XLR Cables (Audio Cables)

Before connecting XLR cables to this unit's analog audio input and output connectors, always attach the supplied ferrite cores to the XLR cables. Attach as shown below.

To attach the ferrite core

Loop the XLR cable one time through the ferrite core, on the side closest to the connector that is connected to this unit, and fix the ferrite core at the specified position.

Preparations 2 Chapter

Connections and Settings 29