Watching the Picture

Before you start

•Turn on the monitor.

•Turn on the connected equipment and play a video source.

•To display the input signal information on the screen when turning on the power or switching the input signal, set “DISPLAY” in the CONFIG menu to ON.

•To select the on-screen language used in the menu, see page 31(EN).

Switching the Picture

1 Press CTRL on the control panel of the monitor. RGB1, YUV, RGB2, LINE, and Y/C buttons light up.

2 Select the input source to be displayed by pressing the following buttons.

RGB1:Selects the audio and video signal input from the RGB1 connectors when the input signal is RGB signal.

YUV: Selects the audio and video signal input from the RGB1 connectors when the input signal is component signal.

RGB2:Selects the audio and video signal input from the RGB2 connectors.

LINE: Selects the audio and video signal input from the VIDEO IN connector and AUDIO IN jack in the LINE connectors.

Y/C: Selects the audio and video signal input from the Y/C IN connector and AUDIO IN jack in the LINE connectors.

Color system or horizontal/vertical frequency

P A L

Signal L I N E · Y / C type

The selected input signal appears on the monitor screen.

You can also switch the input signal from the Remote Commander.

Note

We recommend the input source video equipment equipped with the TBC (time base corrector). If you receive the signal without the TBC, the picture may disappear due to disturbance of the sync signal.

Watching a Still Picture

You can freeze the picture with the STILL button on the Remote Commander. To freeze the picture, press the STILL button when the motion picture is displayed.

You can also freeze the picture by simply pressing the

>button on the control panel.

To resume the normal screen

•Press the STILL button on the Remote Commander or >button on the control panel again.

•Switch the input signal.

Notes

•When operating the menu, the >button functions as for the menu operation.

•The >/.buttons flash while in the still mode.

•When you set DISPLAY to ON in the CONFIG menu, the “STILL” display appears on the top of the monitor. To clear the display, set DISPLAY to OFF.

Input Signal and Monitor Status Information Display

Input signal and monitor status information is displayed on-screen for about five seconds when turning on the power or switching the input signal. To disable this function, follow the steps below.

1 Press MENU.

The main menu appears on the monitor screen.

M A I N

M E N U

 

P I C

C O N T R O L

 

P I C

S I Z E

 

C O N F I G

 

M E M O R Y

 

R E M O T E

 

S T A T U S

 

S E L E C T ENTER

C A N C E L MENU

 

 

 

22 (EN)