Location and Function of Parts and ControlsControl Panel

VOL –

 

VOL +

 

MENU

 

.

 

>

 

ENT

 

RGB1

 

YUV

 

RGB2

 

LINE

 

Y/C

 

CTRL

 

u

!£

!ª

!Á

0

9 8 7 6 5

4 3 2 1

1Remote control detectorReceives the beam from the Remote Commander.

2u(standby) switch/u(standby) indicator Press to turn the monitor on. Press again to go back to the standby mode.

The u(standby) indicator lights up in red in the standby mode.

When the uindicator flashes, see “Self-diagnosis Function” on page 31(EN).

3Power indicatorLights up when the monitor is turned on.Flashes in the power saving mode.

For details on the power saving mode, see “Turning Off the Power Automatically When There Is No Input Signal (Power Saving Function)” on page 30(EN).

4CTRL (control) button

To operate the buttons on the control panel, first press this button. Then the buttons light up or flash that show they can be operated. Press again to deactivate them.

Note

The buttons (except for u(standby) switch 2) on the control panel do not function if you do not press the CTRL button first.

5Y/C buttonSelect the signal input from the Y/C IN jack in the LINE connectors.
6LINE buttonSelect the signal input from the VIDEO IN connector in the LINE connectors.7RGB2 buttonSelect the signal input from the RGB2 connectors.8YUV buttonSelect the component signal input from the RGB1 connectors.9RGB1 buttonSelect the RGB signal input from the RGB1 connectors.0ENT (enter) buttonPress to select the desired item in a menu.!Á >/.buttonsPress to move the cursor (z) to an item or to adjust value in a menu.!ª MENU buttonPress to make the menu appear.!£ VOL (volume) +/– buttons

Press the + button to increase the volume, or the – button to decrease the volume.

8 (EN)